8
Installation Instructions Sub-Frame Hitch
Form No. 1733910-03
Rev. 12/2006
© 2006 Briggs & Stratton, Inc. All Rights Reserved
TP 200-4442-03-AT-SMAN
MANUFACTURING, INC.
500 N Spring Street / PO Box 997
Port Washington, WI 53074-0997 USA
Figure 4. Install Lock Plate - Manual Lift Models
A. Lift Shaft Assy. F. Lift Bar
B. Flat Head Pin (Original) G. Lock Plate
C. Flat Head Pin (New) H. Hair Pin Clips
D. Capscrew I. Spacer
E. Washer
A
B
C
D
E
F
F
G
G
H
I
DOWNWARD PRESSURE LOCK
PLATE - OBSOLETE
Note:The following information applies only
to models produced before October of 2002.
It is being included here for reference pur-
poses ONLY.
MANUAL LIFT MODELS
1. Rest the back of the lock plate (G, Figure 4) against
the spacer (I) and rotate until it lines up with the hole
in the lift bar (F).
2. Secure the lock plate (G) to the lift bar (F) using a flat
head pin (C) and hair pin clip (H).
