Axion / 150Z Series
TP 300-5412---ZT-SN 8/20086
Quick Setup List
Page Setup Procedure Steps to Perform
7 Uncrating ❏ Remove crate & banding.
❏ Place transmissions in ROLL RELEASE position & roll off
skid.
8 Battery Activation & ❏ Charge the battery
(Note: proceed with other setup steps
Installation
while battery is charging).
❏ Install & secure battery.
9-13 Mower Assembly ❏ Install the seat.
❏ Install the seat safety switch.
❏ Set up the ground speed control levers.
❏ Torque the mower blade hardware.
14 Check Fluid Levels ❏ Fill & check Engine oil level.
❏ Reduce & check tire pressures
(Front tires 18-20 psi, rear tires 10-12 psi).
15 Lubrication ❏ Lubricate all grease & oil points.
16 Burnish PTO Clutch ❏ Burnish PTO clutch
(run for 15 seconds, repeat 10 times)
.
16 SAFETY CHECKS ❏ Perform SAFETY INTERLOCK SYSTEM CHECK.
❏ Perform MOWER BLADE STOPPING CHECK
.
(Blade must stop within 5 seconds!)
