33
Error displays/Messages
*1 When the CD/MD changer is connected to the unit,
the disc number of the CD or MD appears in the
display.
*2 The disc number of the disc causing the error
appears in the display.
Radio reception
Preset tuning is not possible.
• Store the correct frequency in the memory.
• The broadcast signal is too weak.
The stations cannot be received.
The sound is hampered by noises.
• Connect a power aerial control lead (blue) or
accessory power supply lead (red) to the
power supply lead of a car’s aerial booster.
(Only when your car has built-in FM/MW/
LW aerial in the rear/side glass.)
• Check the connection of the car aerial.
• The auto aerial will not go up.
tCheck the connection of the power aerial
control lead.
• Check the frequency.
• When the DSO mode is on, the sound is
sometimes hampered by noises.
tSet the DSO mode to off (page 25).
Automatic tuning is not possible.
• The local seek mode is set to “on.”
tSet the local seek mode to “off” (page
24).
• The broadcast signal is too weak.
tPerform manual tuning.
The “ST” indication flashes.
• Tune in the frequency accurately.
• The broadcast signal is too weak.
tSet to the monaural reception mode (page
24).
A programme broadcast in stereo is heard
in monaural.
The unit is in monaural reception mode.
tCancel monaural reception mode (page
24).
RDS
Seek starts after a few seconds of listening.
The station is non-TP or has weak signal.
tPress (AF) or (TA) repeatedly until “AF
off” or “TA off” appears.
No traffic announcements.
• Activate “TA.”
• The station does not broadcast any traffic
announcements despite being TP.
tTune in another station.
PTY displays “--------.”
• The current station is not an RDS station.
• RDS data has not been received.
• The station does not specify the programme
type.
Error displays
(For this unit and optional CD/MD changers)
The following indications will flash for about
5 seconds, and an alarm sound will be heard.
Blank*
1
No tracks have been recorded on an MD.*
2
tPlay an MD with recorded tracks on it.
Error*
1
• A CD is dirty or inserted upside down.*
2
tClean or insert the CD correctly.
• A CD/MD cannot play because of some
problem.*
2
tInsert another CD/MD.
High Temp
The ambient temperature is more than 50°C.
tWait until the temperature goes down
below 50°C.
NO Disc
No disc is inserted in the CD/MD unit.
tInsert discs in the CD/MD unit.
NO Mag
The disc magazine is not inserted in the CD/
MD unit.
tInsert the magazine in the CD/MD unit.
NO Music*
1
A CD which is not a music file is inserted.
tInsert a music CD.
Not Ready
The lid of the MD unit (MDX-40) is open or
the MDs are not inserted properly.
tClose the lid or insert the MDs properly.
Push Reset
The CD/MD unit cannot be operated because
of some problem.
tPress the RESET button on the unit.
continue to next page t
