Getting Started
9
GB
6 Turn on the system.
Press POWER on the unit.
After you press POWER on the unit and
turn on the power, you can turn the system
on and off by pressing ?/1 on the remote.
Notes
• Power remains supplied to the system until you press
POWER on the unit again to set it to off.
• You cannot operate the system using the remote
unless POWER on the unit has been pressed.
• When you will not use the system for a long time,
press POWER to set it to off.
7 Set the color system to PAL or NTSC
depending on the color system of your
TV.
The color system is factory set to NTSC for
region code 3 models, and PAL for other
region code models.
Each time you press PAL/NTSC, the color
system changes as follows:
NTSC t PAL t Multi t
NTSC (P-Scan) t PAL (P-Scan) t
Multi (P-Scan) t NTSC t ...
Notes
• A disturbance in the TV screen may be present for a
moment after changing the color system as described
above.
• When you play back a disc recorded in a different
color system from the one you set to the unit, the
picture image may be distorted.
• To set the color system, see page 22.
To connect optional components
See page 34.
Inserting two R6 (size AA)
batteries into the remote
Slide and remove the battery compartment lid,
and insert the two supplied R6 (size AA)
batteries, E side first, matching the polarities
shown below.
Note
If you do not use the remote for a long period of time,
remove the batteries to avoid possible damage from
battery leakage and corrosion.
Tip
With normal use, the batteries should last for about six
months. When the remote no longer operates the
system, replace both batteries with new ones.
e
E
e
E
