18
Playing a tape
You can play any type of tape, TYPE I
(normal), TYPE II (CrO2) or TYPE IV (metal).
The deck automatically detects the tape type.
4
p
P
º/‚
3
VOL+/–
≠/±
DOLBY NR
1/u
(Power)
4
π
∏
2
≠º/
‚±
1
VOLUME
+/–
1 Press § PUSH of the front cover
and insert a recorded tape into the
deck.
2 Press FUNCTION repeatedly until
“TC” appears.
3 Press DIR MODE on the remote
repeatedly to select to play one
side or * to play both sides.
4 Press · (or TAPE ª· on the
remote).
Press ª (or TAPE ª· on the remote
again) to play the reverse side. The tape
starts playback.
To
Stop play
Pause
Fast-forward
or rewind
Find the beginning
of the current or
succeeding track
Remove
the cassette
Adjust the volume
Tips
•Pressing TAPE ª· on the remote while the
power is off automatically turns on the power and
starts tape playback if there is a tape in the deck
(One Touch Play).
•You can switch from another source to the tape
deck just by pressing TAPE ª· on the remote
(Automatic Source Selection).
•When you want to reduce the hiss noise in low-
level high-frequency signals, press DOLBY NR on
the remote before step 4 so “a” appears.
* The deck stops automatically after playback both
sides five times.
With the side you want
to play facing forward
Do this
Press π.
Press ∏. Press again to
resume playback.
During stop, press ‚±
or ≠º (or º/‚
on the remote).
During playback, press
≠º or ‚± (or ≠/±
on the remote).
Press § PUSH.
Press VOLUME +/– (or
VOL +/– on the remote).
1/u
(Power)
