6
!ª LINE A signal input/output connectors
Inputs/outputs the Composite signal of NTSC/PAL
system.
VIDEO IN connector (BNC)
Connect to the composite video signal output of video
equipment.
VIDEO OUT connector (4-pin)
Loop-though output of the VIDEO IN connector. When
no cable is connected, VIDEO IN signal is terminated at
75 Ω.
AUDIO IN connector (phono)
Connect to the audio output of video equipment.
@º AC IN connector
Plug in an AC power cord.
@¡ CONTROL S IN/OUT connector
Connect to the CONTROL S jacks of other Sony
equipment. It is then possible to control the whole
system with a single remote commander.
@™ PHONES jack
Connect headphones (not supplied).
Rear • Bottom
!™ MAIN POWER switch
Turns on or off the main power of the unit.
!£ Hanging plate
You can hang the unit on the wall, or attach the stand
and place on a table.
!¢ Security lock ( )
You can attach the Kensington’s security cable (not
supplied).
!∞ RESET button
Recalls factory settings of the adjusting parameters
excluding INDEX, U SCAN, LIGHT, MUTE and DISP.
Press twice.
!§ CONTROL connector (4-pin)
Connect to the control jack of the equipment with which
you want to control this unit. The signal protocol is
VISCA.
!¶ LINE C signal input connectors
Inputs the analog RGB (computer/video)/YUV (Y/B-
Y/R-Y) signal.
IN connector (3-row D-Sub 15-pin)
Connect to the RGB or YUV (Y/B-Y/R-Y) signal output
of video equipment or a computer.
AUDIO IN connector (phono)
Connect to the audio output of video equipment or a
computer.
!• LINE B signal input/output connectors
Inputs/outputs the Y/C signal of NTSC/PAL system.
Y/C IN connector (4-pin)
Connect to the Y/C video signal output of video
equipment.
Y/C OUT connector (4-pin)
Loop-though output of the Y/C IN connector. When no
cable is connected, Y/C IN signal is terminated at 75 Ω.
AUDIO IN connector (phono)
Connect to the audio output of video equipment.
Functions of Controls
