A SERVICE OF

logo

9
Mode Setting
Specifications of the External
HD/VD Outputs
The amplitude level is the typical value when
terminated with 10 k. The external HD and VD can
be output when you set the INT/EXT switch to INT.
Specifications of the WEN
Output
The amplitude level is the typical value when
terminated with 10 k. When the partial scanning is
used, the pulse width is less than the above value.
4.5V
0V
625 H(1N)
312.5 H(2I)
2
µ
sec to 1/4 sec
4 to 5.0V
0 to 1.0V
4.5V
0V
4.5V
0V
HD
VD
Specifications of the Trigger
Pulse
Input impedance; 10 k or more.
The voltage and pulse width used are measured at pin
11 of a 12-pin multi-connector on the rear panel.