15
CHAPTER 2 – Connections and Remote
Conguring Your Remote to Control
Other Devices
The TV and Amp buttons on the remote control may be
individually congured to control a range of televisions,
receivers and ampliers from well known manufacturers.
Conguring the Remote to Control a Television
Press the • TV and
O
Select buttons simultaneously;
hold them down for one second.
The TV button will remain lit for 20 seconds; the congura-
tion process must be completed during this time.
Enter the 3 digit numeric code matching the •
manufacturer of your television from the list in Remote
Control Codes.
Press the • TV button again.
The TV button will blink twice to indicate that the congura-
tion has been accepted. If the TV button does not blink,
begin the process again, taking care to enter the number
exactly as printed in the list. If the television is switched on
during the conguration process, entering the correct code
will cause the television to go into standby.
To congure the remote to control your receiver or ampli-
er, follow the above procedure, pressing the AMP button in
place of the TV button, and using the appropriate numeric
code for your amplier.
Remote Control Use In a Multi Room System
Your remote control may be congured to control additional
TGM-100C clients in the system.
Conguring the Remote with a Default Output
Press the • Audio Server and
O
Select buttons
simultaneously; hold them down for one second.
The Audio Server button will remain lit for 20 seconds; the
conguration process must be completed during this time.
Enter the 3 digit code corresponding to the output you •
would like to control. For example, to set Output 2 as
your default output press: 0, 0, 2.
Press the • Audio Server button again.
The Audio Server button will blink twice to indicate that
the conguration has been accepted. If the Audio Server
button does not blink twice begin the process again, taking
care to enter the number correctly.
The remote control will now only control the rst TGM-
100C client in the system. Additional remotes may be
programmed to control other clients using this method.
