THREADING THE MACHINE
This operation is important to carry out correctly as by not doing so many
sewing problems could result. We suggest you read through the procedure
carefully and carry out this process several times before using the machine to
familiarise yourself with the process.
Disconnect the AC adapter from the machine before threading.
Raise the thread take-up lever to its highest position by turning the
handwheel counterclockwise. Raise the presser foot.
Place a spool on the spool pin, with thread coming o as shown.
1: Draw the end of thread around under the thread guide.
2: Hold the thread close to the spool with your right hand. Use your left hand
to draw the end of the thread down along the right channel and around
the bottom of the guide plate.
3: Firmly draw the thread up along the left channel. Pass the thread through
the eye of the take-up lever from right to left.
4: Draw the thread down along the left channel and pass it behind the needle
bar thread guide from the left.
5: Thread the needle from the front. Pull the thread through the needle eye.
USING THE SUPPLIED THREADER LOOP
5: Insert the threader loop through the needle eye from behind.
6: Pass the thread end through the threader loop. Pull the threader loop out
from the needle eye. Remove the thread end from the threader loop.
Page 10
TAKE-UP LEVER
THREAD
GUIDE
