The preset setting screen is displayed when the Preset key is pressed.
Pressing the key again exits the preset setting screen in any of the following settings, displaying the
Input/Output Gain Setting screen.
11.1. Preset Memory Save
Set parameters can be stored in memory (number of memories: 16).
[Parameters that can be stored in memory]
Input channel parameters: PAD, Phantom power, Line input mode selection, Line input selection, Input trim
gain, Input trim polarity, High-pass filter, Equalizer (low and high frequencies),
Compressor/auto-leveler mode selection, Compressor/auto-leveler, Level
sense, Gate, Auto-mixing group, Ducker, NOM attenuation ON/OFF, Input
channel gain, Channel ON/OFF, Group trim gain, and Bus assignment
Output channel parameters: Output channel gain, Group trim gain, Channel ON/OFF, Filters 1 – 6 (including
crossover), Compressor, and Delay
Microphone bus parameters: Feedback suppression (Dynamic mode ON/OFF, Filter number, and Filter
parameters set in Auto and Dynamic modes), Echo, and Bus assignment
Others: Stereo link, Group, Crossover configuration, NOM attenuation, and Channel
selection status
No . 1 OK
No. 1 OK
No. 2 OK?
No. 16 OK?
.
