A SERVICE OF

logo

4 Replacement Procedures 4.26 Fluorescent lamp
4-70 PORTEGE A200 Maintenance Manual (960-499)
4. Bezel set
<Procedure>
1) Hook the upper side (TAB side) of bezel to the three latches of frame. ?
2) Latch the side.
3) Mate the lamp side. ?
Caution: 1. Do not damage the TAB.
2. Make sure the three latches of bezel are hooked.
3. The PCB GND-CU shall be within the bezel.
Figure 4-59 Replacing TMD fluorescent lamp(10)
Folding of reflector
shall be within bezel.
PCB GND
-
CU shall be
within bezel.
PCB GND
-
CU shall
be within the bezel.
?
?
?
?