A SERVICE OF

logo

Replacement Procedures
4.9 Optical disk drive
NOTE: Do not apply excessive force to the top of an optical disk drive.
Do not touch the shaded portion of the figure below, when the drive is removed
or installed.
Removing an optical disk drive
The following describes the procedure for removing an optical disk drive (See Figure 4-
11and 4-12).
1. Remove Keyboard and next remove the following screws securing an optical disk
drive.
M2.5×5.0B FLAT BIND screw x1
2. Disconnect an optical disk drive toward the arrow direction from the connector
CN26 on the system board.
ODD screw
Figure 4-10 Remove an optical disk drive
Satellite P300 and Satellite Pro P300 Maintenance Manual (960-Q08)
4-33