Note:
For TL-SL3428, when using the SFP port with a 100Mbps module or a gigabit module,
■
you need log on to the GUI (Graphical User Interface) of the Switch and configure its
corresponding Speed and Duplex mode on Switching
→
Port
→
Port Config page.
For 100Mbps module, please select 100MFD while select 1000MFD for gigabit module.
By default, the Speed and Duplex mode of SFP port is 1000MFD.
For TL-SL3452, the SFP port can be only used with a gigabit module.
■
Rear Panel
■
The rear panel of TL-SL3428 is shown as the following figure.
Grounding Terminal
Power Socket
Rear Panel of TL-SFigure 1-3
L3428
The rear panel of TL-SL3452 is shown as the following figure.
Grounding Terminal
Power Socket
Rear Panel of TL-SL3452Figure 1-4
Grounding Terminal
The Switch already comes with lightning protection mechanism. You can also ground
the Switch through the PE (Protecting Earth) cable of AC cord or with Ground Cable.
For detailed information, please refer to Chapter 3 Lightning Protection.
Power Socket
Connect the female connector of the power cord here, and the male connector to
the AC power outlet. Please make sure the voltage of the power supply meets the
requirement of the input voltage (100-240V~ 50/60Hz).
Caution: Please use the provided power cord.
Introduction
