3 Press and hold both the Device button selected in Step 1
and the SEL/PLAY button for about three seconds, until
the LCD on the SL-9000 shows LEARN. The SL-9000 is
now in the learning mode.
Note: Each of the following steps must be completed within 20
seconds. If the remote does not receive any new commands with-
in the allotted time, it will return to its normal operating mode.
4 Press and release a button on the SL-9000 you have
selected to learn the new function. The LCD will show
READY.
5 Press and hold the button on the original remote control
for about 3 seconds from which you are learning the new
function. The LCD on the SL-9000 will show – – – –
indicating that it is receiving the information from the
original remote control.
6 Release the button on the original remote control. The
LCD on the SL-9000 will show RETRY.
7 Press and hold the same button on the original remote
once again, for about 3 seconds. The LCD on the SL-9000
will flash GOOD, the Device Mode and then return to
LEARN, verifying that the new function has been
learned.
14
14
Using Your Remote
