Operation
18 800092-01 Rev. A www.wegener.com
Figure 3.5: iPump 562 OSD Current Channel Screen
Use the Current Channel screen to set or display the channel information.
Table 3.3: Channel Information Options
Configure
LNB options
LNB Setup screen
Use following steps to display LNB Setup screen on the OSD menu:
1. Press any push-button on the front-panel to display the Main Menu.
2. Press the down arrow button to select Carrier Settings.
3. Press Enter.
4. Press the down arrow button to select LNB Setup.
5. Press Enter. Figure 3.6 details the LNB Setup screen.
6. To navigate the screen, use down arrow and Enter to select an option. When the
corresponding value of that option on the left is selected, use up or down buttons to
set to the desired setting. Press
Enter when done. Move to the next option using up
or down button or left arrow to exit to the previous menu level.
Option Possible values Comments
Preset Perm, Command, Last
Success or Current
Only Perm option allows other options to be set.
The channel set using the Compel Command.
Modulation QPSK/S2QPSK/S28PSK -
FEC Ratio 1/2, 2/3, ¾, 5/6, 7/8 -
Frequency
Data Rate
Symbol Rate Automatically calculated and displayed only
Program Set to the desired program # in the carrier
Tag Site The tag #15 is a special value
