Press [Select] to cycle through each of these satellites until the asterisk is next to the satellite you wish to nd.
Then press [Enter].
The TRAV’LER Interface will ask you to conrm the change:
Press [Select] to move the asterisk to YES.
The Trav’ler Interface will acknowledge your selection and ask:
Pressing [Enter] or choosing YES, will stow the TRAV’LER and turn it off.
Pressing [Select] then [Enter] or choosing NO will start a new search for your chosen satellite.
EMERGENCY OFF:
The Winegard TRAV’LER antenna comes with an emergency Power Off feature.To activate it, press
and hold [POWER] and then press [SELECT] while still holding [POWER]. The TRAV’LER antenna will
stop where it is and turn off.
If the Emergency Power Off is used, the TRAV’LER antenna may not be in a safe position for
travel. DO NOT MOVE THE VEHICLE UNTIL YOU ARE ABLE TO STOW THE UNIT. See Ready to
Travel, top of page 4, Operation section.
Manual ###
*YES NO
POWER OFF
*YES NO
5
!
The TRAV’LER will remain in
manual mode until you select
multi-sat mode again.
To use the Manual Search Mode to select a specic satellite, choose Search Mode by pressing the [Enter] button.
Once in the Search Menu you may choose from:
MULTISAT MODE (The normal search mode)
MANUAL 61
MANUAL 72
MANUAL 82
MANUAL 91
MANUAL 101
MANUAL 107
MANUAL 110
MANUAL 111
MANUAL 119
MANUAL 129
MANUAL 148
MAIN MENU (returns to the User Menu)
EXIT (Enters the Search Routine)
OPERATION
Ready to Travel?
To stow the unit when you are ready to travel:
Press [Power] one time.
The unit will stop what it is doing and begin to return to the stowed position. The TRAV’LER Interface WILL NOT
TURN OFF unless the TRAV’LER mount is successfully stowed.
Manual Mode:
The TRAV’LER antenna is an extremely versatile satellite antenna and can be manually set to nd many different
satellites individually. NOTE: This function is rarely used.
To enter the Manual Search Mode while the TRAV’LER is stowed:
Press the [Power] button and hold it for two seconds to turn the unit on.
While the Trav’ler Interface reads:
Press and hold the [Enter] button for two seconds.
The TRAV’LER Interface will ask if you wish to enter the User Menu:
Press [Select] to choose YES and then press [Enter].
The User Menu consists of four choices:
Search Mode
Diagnostics
Installation
Exit
NOTE: Diagnostic and Installation Menus are not required for normal operation and should only be entered by a
trained professional.
POWER OFF
STOWING
4
WINEGARD BURLINGTON
POWER ON
ENTER USER MENU
*YES NO
OPERATION
!
The SK-7003 will only see
the 107° and 111° satellites in
manual mode.
LG SHAW DIRECT
STOWING
