26 Hydraulic Installation
PN-46018 (Rev. 3/15/02)
#56038 Valve Kit & #46047 Hose Kit Cont’d
3
1
PYB
5
8
6
OUT
7
6
5
2
1
IN
CD5618C-Var
Figure 30 #46047 Hose Kit
PBY
IMPORTANT
If hydraulic lines are not connected as shown in
he mounting kit manual or the tractor manual, the
ontrol valve my be damaged. A blocked outlet
return) or improper hose connection will cause
ressurized oil to enter the return circuit and dam-
ge the valve or the tractor hydraulic system.
Use care when identifying valve ports. Cable
perated loader valve is mounted in the inverted
osition (stems down as shown in Figure 33.)
If tractor hydraulic system pressure is greater
han 2650 psi, make sure the valve used is
quipped with a relief valve.
Install OUT Line
1. Connect 90-degree end of 100” hose (3) to adapter
in valve OUT port. Refer to Figure 30.
2. Route hose under fuel tank, then over right rear
axle to tractor Return port (above the upper right of the
PTO shield) and connect. Use straight adapter (1) and
90-degree elbow (2) as shown in Figure 31.
1. 315058 1/2 NPTM x 3/4 JICF Adapter
2. 313032 3/4 JICM x 3/4 JICF 90° Elbow
3. 46044 100” Hose
Figure 31 Tractor Return (OUT) Port
75$&725
5(7851
3257
