Chapter 24 Configuration: Multicast
GS1900 Series User’s Guide
137
24.2.3 The Edit IGMP Screen
Use this screen to configure the IGMP VLAN settings. Click Configuration > Multicast > IGMP
> VLAN > Edit to open this screen.
Figure 118 Configuration > Multicast > IGMP > VLAN > Edit
The following table describes the labels in this screen.
State Displays the switch current VLAN querier entry as Enable or Disable.
Version Displays the switch current VLAN querier entry version.
Table 99 Configuration > Multicast > IGMP > VLAN (continued)
LABEL DESCRIPTION
Table 100 Configuration > Multicast > IGMP > VLAN > Modify
LABEL DESCRIPTION
IGMP Edit
VLAN List Enter the ID of a static VLAN; the valid range is between 1 and 4094.
IGMP State Select the status of the VLAN to Enable or Disable the function.
Router Ports
Auto Learn
Select Enabled to have the Switch learn multicast router membership information of any
VLANs automatically.
Query
Retry Enter the number of query retry times. The value can be between 1 and 7.
Interval (sec) Enter the amount of time (in seconds) between general query messages sent by the router
connected to the upstream port. The value can be between 30 and 18000.
Max. Response
Interval (sec)
Enter the amount of time (in seconds) the router connected to the upstream port waits for
a response to an IGMP general query message.
