Filter
Top Products
24
Programming a Macro
You can program your MF-355RF to issue a sequence of commands
at the press of one button. For example, you may want to turn off
your TV, VCR and Satellite Receiver at the same time.
Example: To set up the Macro mentioned above on the key
labeled A on your MF-355RF:
1. Press and hold SETUP until red light (LED under device key)
blinks twice (the red light will blink once then twice).
2. Press 9 9 5.
3. Then press the A key to which the Macro will be assigned.
4. Next press TV, POWER, VCR, POWER, SAT, POWER.
5. To store the Macro, press and hold SETUP until red light
(LED under device key) blinks twice (the red light will blink
once then twice).
Result: whenever you press the A key, the MF-355RF will turn off
your TV, VCR and Satellite Receiver.
- Each MACRO can consist of a maximum of 15 key strokes.
- Make sure that you program a Macro on a spare key that you
don’t use in any mode (e.g. A, B, C, D keys).
- Once you program a Macro on a specific key, the sequence will
work regardless of the mode you are using.
- If you had to hold down a key for a few seconds on the original
remote control to get a function, this function may not work in a
macro on your MF-355RF remote.
To erase a Macro
Example. To erase the Macro from the A key, press:
SETUP* 9 9 5 A key SETUP*
* Here you must hold down SETUP until the red light blinks twice.