Filter
Top Products
10
Sketch map
Push the power switch (O: Off, I: On).
Use the power cord connect to an earthed 120V, 60Hz AC outlet.
Signal input and other terminals:
ANT1 & ANT2: 75Ω Coaxial connector for Antenna/Cable Network
.
Note: ANT 1 is for ATSC (DTV), and ANT 2 is for NTSC. (Refer to page 16.)
OPTICAL OUTPUT: Connect the optical output to the optical input connector of the Amplifier.
(Only for DTV)
RS-232: The D-SUB 9 Pins terminal is used as a control port for serial communication
between
PC and Panel. (Only for after-sales service & DTV)
Audio Output: Connect audio amplifier or other TV set that with audio input.
HDMI INPUT: For high quality picture display purposes. Connects to HDMI or DVI (with DVI to
HDMI Adapter-not provided) digital output connector of the DVD or HDTV Set-top box.
D-Sub (VGA) INPUT: For PC display purposes. Connects to the Mini D-Sub 15 Pins analog
output connector of the PC display card.
VGA/DVI AUDIO INPUT: Connect the audio input terminal to the audio output terminal
of DVD
or HDTV Set-top box with VGA/DVI output terminal.
YPbPr (COMP1) INPUT: Connect the Component video input terminal to the Component
output
terminal of the video output device.
YPbPr
(COMP1) Audio INPUT: Connect the audio input terminal to the audio output terminal
of the video output device.
YPbPr (COMP2) INPUT: Connect the Component video input terminal to the Component
output
terminal of the video output device.
YPbPr
(COMP2) Audio INPUT: Connect the audio input terminal to the audio output terminal
of the video output device.
S-Video INPUT: Connects to the S-Video out jack of your VCR or other video equipment that
has S-Video.
S-Video Audio Input: Connect the audio input terminal to the audio output terminal of the
S-Video output device.
Video Input: Connect the component video input terminal to the video output terminal of the
video output device.
Video Audio Input: Connect the audio input terminal to the audio output terminal of the Video
output device.
4.3 Rear View
REAR VIEW REMOTE CONTROL