ALK Technologies 7 Flat Panel Television User Manual


 
Getting started
12
01
Setting up a built-in GPS Receiver
If you selected Built-In you will need to choose
between Automatic and Manual. We recommend
Automatic setup.
With Automatic selected, tap Finish. CoPilot will fi nd
and connect to the GPS receiver in your device.
To set up Manually, select Manual, you will need to
select the COM Port that the GPS is connected to and
the BAUD rate for the device. Please consult
your device manufacturer for this information.
When you have entered the information tap Finish to
continue. Once setup has been completed select Finish
to complete the process.
Note: If you get the message GPS Setup failed the
COM Port and/or BAUD information were incorrect.
Please try again.
You’re ready for your fi rst trip!
Note: The fi rst time you use the GPS receiver it may take a moment
to determine your position.
Using other GPS receivers
If you selected Other you will need to connect the GPS Receiver manually.
You will need to select the COM Port that the GPS is connected to and the BAUD
rate for the device. Please consult your device manufacturer for this information.
Tap Finish to continue. Once setup has been completed tap Finish to exit.
You’re ready for your fi rst trip!
Note: The fi rst time you use the GPS receiver it may take
a moment to determine your position.
Tips: GPS Signal
GPS signal will be limited inside buildings, tunnels or
parking lots. To work effectively the GPS receiver
needs to have a clear line of sight to the sky.
User Guide 01 Getting started