Filter
Top Products
Data Cable Partitions—Installation2
Installing Data Cable Partitions
Use the procedure in this section to install all of the Data Cable Partitions. You can install Data Cable
Partitions on a NetShelter Enclosure or a PDU.
1. Squeeze the two sides of the Pass-through Data Cable Partition to insert the fastening tabs into a
set of square holes.
2. Determine the width that will be required for data cable routing, then install the Data Cable
Partition at the front of the roof with a solid side in the same manner as step 1.
Note: Use a Data Cable Partition with a solid side at the front of the enclosure to
ensure a finished appearance.
ns1299b
ns1300b