Filter
Top Products
Operating Your TV
Once you have connected your TV to an antenna or cable system, unplugged the TV in, and
put batteries in the remote, you are ready to use the TV. The first thing you should do is
program your TV so it memorizes all of the available channels.
Turning Your TV On
Programming Your TV’s Channel Memory
Your TV’s memory determines the channels that are available using the CH buttons. If a
channel is not in memory, you can tune to it with the number buttons, but not with the CH
buttons. Follow these steps to program your TV’s memory:
1. With the TV on, press the MENU button.
2. Use the CH buttons to select the SETUP and press VOL .
3. Use the CH buttons to select ANTENNA, then use the VOL buttons to select AIR or
CABLE. If you connected an antenna to your TV, select AIR; if you connected a cable system,
select CABLE.
4. Use the CH buttons to select AUTO PROGRAM, then use the VOL button to begin
the AUTO PROGRAM process. This process takes a few minutes.
5. Press the MENU button to return to normal TV viewing.
Your TV’s channel memory will not be affected by a power outage. You will not need to re-
program the memory unless you change the type of cable or antenna connected to your TV.
Chapter 3: Operating your TV-10
3
1. To turn on your TV, press the POWER button on
the remote control. You can also use the POWER
button on the front panel. Make sure your TV is
plugged in before you try to turn it on.