Filter
Top Products
- 13 -
Source Device Selection
The VS481A HDMI Switch offers easy and flexible source device
selection with either the front panel pushbuttons, with the remote
control, or through the RS-232 serial interface.
Note: Whenever the VS481A is powered on, it automatically
selects Port 1 if there is no video input source connected.
You may choose one of the methods outlined below to
select a different port.
Manual Selection
To select a source device, press the pushbutton that corresponds
to the port it is connected to.
Note: The SELECTED LED (green) light indicates which port is
currently selected.
Remote Control Selection
To select a source device with the remote control, press the
number button that corresponds to the port it is connected to.
Alternatively, you may also cycle through the available source
devices by pushing the Port Up and Port Down buttons on the
remote control unit.
Use the Port Up button to select the next available port in
ascending order (from left to right on the front view panel).
Use the Port Down button to select the next available port in
descending order (from right to left on the front view panel).
Note: 1. The maximum range of the remote control unit is 10
meters (30 ft)
2. Aim the remote control unit at the IR receiver located on
the front panel of the VS481
A. For optimum
performance, make sure there is a clear line-of-sight
between the remote control unit and the IR receiver.
vs481a.fm Page 13 Thursday, February 2, 2012 1:21 PM