Audiovox VE 640 Flat Panel Television User Manual


 
-4-
1) Choose an appropriate mounting location underneath a cabinet or shelf. Close proximity to an
electrical outlet and a TV antenna or cable connection will facilitate a neat, easy installation. Do
not mount the VE-640 above a range or oven. Be sure that the location chosen will provide
adequate access to the electrical connectors on the rear of the unit before continuing.
2) If the location chosen has bottom edge molding it may be necessary to use the mounting
spacers provided to effectively lower the VE-640’s below or even with the molding. Measure
the distance between the bottom of the molding and the bottom of the cabinet. For larger moldings
choose a combination of spacers which will allow the VE-640 to be secured to the bottom of the
cabinet.
3) Measure the thickness of the bottom of the cabinet or shelf and the spacers chosen. Select the
shortest screw length which will secure the VE-640 to the bottom of the kitchen-cabinet.
4) Cut out the template supplied and tape it in place onto the cabinet surface to be drilled. Center
punch the four holes indicated on the template and remove the template.
5) Carefully drill four 1/8” holes at the locations marked above. Place the screws selected
through the VE-640 and then through the spacers (if required from the bottom-up).
NOTE: To facilitate wiring, connect all wires to the rear of the unit before attaching to the
cabinet.
6) Position the VE-640 and screw it in place using the selected screws. Do not overtighten.
8) Connect your TV antenna or cable system to the antenna connector on the rear of the VE-640.
9) Plug the AC wire into the AC input connector on the rear of the VE-640 and then into the wall.
10) If using the speaker phone feature, plug the VE-640 into a phone jack.
11) Attach the FM Dipole Antenna to the FM Antenna screws.
12) Route the wires safely away from heat and moisture sources and secure them in place, using
the self adhesive wire mounting clip provided.
UNDER CABINET INSTALLATION
Cabinet or
Shelf
Bottom
Edge
Molding
FRONT VIEW
SIDE VIEW
3/4” or less
Spacers
Spacers