Filter
Top Products
-8-
NOTE:All settings will be performed with the VE-640 turned off.
1) Press the SET button and the minutes will flash.
2) Use the channel up and down button to set the minutes.
3) Press the volume up/down buttons to toggle between the hour and minutes.
4) Use the channel up and down buttons to set the hour. (Check AM/PM indicator)
5) Press the ON/OFF button to confirm time setting.
SETTING ALARM
1) Press the SET button twice and VE-640 is in alarm mode
indicated by five flashing LED’s.
2) Use the channel up and down button to set the minutes.
3) Press the volume up/down buttons to toggle between the hour and the minutes.
4) Use the channel up and down button to set the hour. (Check AM/PM indicator)
5) Press the SET button three times to return to the time display on the LCD panel. The alarm is
now set.
SETTING THE ALARM TONES
1) Press the SET button twice (power off)
2) Press the SEEK button down once to hear the alarm tone.
3) Pressing channels 1, 2, or 3 will select different tone.
4) While the alarm is sounding set the alarm volume by pressing the volume up/volume down
buttons.
5) Press the SET button to select this tone and volume combination.
6) When the alarm sounds, press the set button to turn it off.
SETTING THE CABLE TV MODE
1) Press the SET button three times to enter the cable configuration mode. AIR appears on the
display. (Pressing channel 1 button switches from broadcast TV (VHF or UHF) to cable TV).
2) Press the channel 1 button, and switch to cable. CABL will appear on the LCD.
3) Press the SET again to display the cable system mode (Standard, IRC, HRC).
When the desired mode is reached, press the SET button to confirm.
4) Press the channel 1 button to select the cable mode (STD/IRC/HRC).
OPERATION
TURNING THE VE-640 ON/OFF
1) Press the ON/OFF button to turn the unit on.
2) Press the ON/OFF button again to turn the unit off.
CHANNEL TUNING SET UP
In addition to normal broadcast reception of VHF and UHF channels, if you are a Cable TV subscriber,
your new TV is capable of receiving many unscrambled Cable channels without the use of a converter
box. When set to Broadcast TV it receives CH2-CH69. When set to one of the CATV modes (STD,
HRC, or IRC) it receives CH1-CH125. NOTE: Most cable companies broadcast in STD Mode.
POSITIONING THE SCREEN
Pivot the screen forward until a comfortable viewing angle is reached. The screen may also be rotated
from side to side. Do not force the screen beyond its rotational limit . The VE-640 is now ready for use.
Pressing the power button on the TV or the remote will turn the system on or off. Remember to turn the
unit off and pivot the screen to the closed position when not in use.
SETTING THE TIME