Filter
Top Products
18
N. Setup
1. General Setup Page
1)With no disc inside the player, press ‘SETUP’ to display the Main screen
of the Setup Menu on the screen and “General Setup Page” appears. At
the same time, “ ” is highlighted. Press ‘SETUP’ again to exit the
Setup Menu.
2) Press the
or
buttons to select the other menus in general
setup page.
3) With “TV Display” highlighted press the ENTER button.
4) Press to enter the sub menu.
5) Press the
or
button to select the desired option in the sub
menu and press the ENTER to confirm your selection.
6) Repeat steps 3-5 for other menus.
Note: Press
to return the previous menu.
a) TV Display
* Normal/PS: When the player outputs signal to a normal TV, a nor-
mal picture is shown on the full screen.
* Normal/LB: When the player outputs signal to a normal TV, a nor-
mal picture is shown on the screen with a black strip at both the top
and bottom of the screen.
* Wide: When the player outputs signal to a wide screen TV, a
wide picture is shown on the full screen.
b) Angle Mark
*On: Allows access to the angle feature if contained on the DVD.
*Off: The unit will not display the angle mark feature.
NOTE: Not all discs contain above features. The above features are
disc dependent.
b) Screen Saver
*On: Enables screen saver
*Off: Disables screen saver
*NOTE: The DVD player will enter the Screen Saver mode after ap-
proximately three minutes if the same image remains on the screen.
PDF created with FinePrint pdfFactory Pro trial version http://www.fineprint.com