Filter
Top Products
10
Cleaning a Disc
To clean a disc use a soft cloth without any cleaning agents.
Only wipe from the center hole towards
the outer edge, never in toward the center.
Using the Remote Control Handset
1. The remote control uses a pre-installed Li-ion type
battery. To prevent the battery from discharging, we’ve
inserted an insulating strip. Please pull it
out prior to first use.
If the remote control should begin to operate unreliably
replace the battery with a new battery of the same type.
To replace the battery open the battery
compartment. Push the retention clip in the direction of
arrow and pull out the battery mounting.
2. Before you remove the battery, remember the battery po-
sition. The ‘+’ marking must face upwards, otherwise
the remote control will not work and may be damaged. Re-
place the cover.
3. Please point the remote control towards the main unit when operating the but-
tons. The remote control works best with a distance less than 16 feet (5m) and
in an angle of up to 45
o
center of the front of the unit. Obstacles between the
remote control and infrared sensor will adversely affect operation of the remote
control.
Batteries should disposed in an environmentally correct manner. . Never
throw batteries into fire.
If the remote control is not to be used for an extended period of time, please
remove the battery from the compartment to prevent damage by battery
leakage.
When replacing the battery, please observe the polarity. The ‘+’ must face
upwards.