Filter
Top Products
Adjustment in PC mode
To enter into PC mode
Repeatedly press button on the remote control or SOURCE button
on the set's panel until the screen display PC, which indicates that the set
is in PC mode.
Please connect VGA input and be sure that there is VGA input signal. The
signal format should be one of the follows:
640 X 480 @60Hz - 75Hz
800 X 600 @60Hz - 75Hz
1024 X 768 @60Hz - 75Hz
1280 X 768 @ 60Hz - 75Hz
We recommend you to use 1024X768 @60Hz (4:3) or 1280X768@60Hz
(16:9) so that the set can obtain the best picture.
When PC signal format changes or when you switch to PC mode by
button, the set corrects picture automatically including frequency and
phase to obtain the best display. During the process of auto correction, all
buttons on the remote control and set's panel do not work until this
process is finished.
When the set displays some signal formats that are nonstandard and can
not adjust by itself to the best displaying status, now you can press
AUTO.ADJ button to correct the displaying again.
PC signal format
Use AUTO. ADJ button
PC
33