Filter
Top Products
Changing Volume Lock
The remote comes preset to allow independent volume control of each selected
device (Global Volume Unlock). However, you may change the Volume Lock setting
to Global Volume Lock so that one device's volume will control volume in all other
modes. After that, you can perform Individual Volume Unlock on a selected device to
set its volume control for independent operation or Global Volume Unlock to remove
all volume locking.
Locking Volume Control to One Mode (Global Volume Lock)
1. Press and hold SET until the red LED blinks twice; then release.
2. Enter 9-9-3 and then press the mode key for the device you want to control volume
(for example, DVD). The LED blinks twice. Now when you press VOL+, VOL-, or
Mute, the selected device (for example, DVD) will control the volume regardless of
the current mode.
Unlocking All Volume Control (Restoring Global Unlock)
1. Press and hold SET until the red LED blinks twice; then release.
2. Enter 9-9-3 and then press VOL+. The LED blinks four times.
Volume is now independently controlled for all programmed devices.
Unlocking a Single Device's Volume Control
1. Press a device key (VCR/DVD, CBL/ SAT, or AUX).
2. Press and hold SET until the red LED blinks twice; then release.
3. Enter 9-9-3 and then press VOL-. The LED blinks four times.
Volume is now independently controlled for the selected devices.
Troubleshooting
Programming your Remote Control
Problem Solution
LED does not blink when you
press a key.
Replace new batteries.
LED blinks when you press a key,
but device does not respond.
Make sure the remote is aimed at your device and is
not more than 15 feet away.
LED blinks one long blink.
An entry error has occurred (for example, wrong key).
Try entry sequence again.
Remote does not control devices
or commands are not working
properly.
Try all listed codes for the device. Make sure the
device operates with an infrared remote control.
CARE
=
=
=
=
Keep the remote dry. If it gets wet, wipe it dry immediately.
Use and store the unit only in normal temperature environments.
Handle the remote gently and carefully. Don't drop it.
Wipe the remote with a damp cloth to keep it looking like new.
43
Other Information
Checking the Codes
If you have set up the remote using the procedure in “Searching for Your Code”, you
may need to find out which four-digit code is operating your equipment. For example,
to find out which code is assigned to your DVD:
1. Press DVD once.
2. Press and hold SET until the red LED blinks twice; then release.
3. Enter 9-9-0. The LED blinks twice.
4. To view the code for the first digit, press 1. Count the LED blinks (for
example, three blinks = 3), and write down the number in the appropriate
code listing in step 6 under “Programming a Device”.
If a code digit is 0, the LED does not blink.
5. Repeat step 4 for the four remaining digits, using 2 for the second digit, 3 for
the third digit, 4 for the fourth digit, and 5 for the fifth digit.
6. To check for other device codes, repeat steps 1 to 5, substituting the device
key for DVD.