Filter
Top Products
E
12
USING THE TV
Connect an antenna or CATV cable or Satellite system to the TV antenna terminal
before searching TV channels.
Searching for TV channels automatically
(Only appears to the first time Power ON)
Watching television
Viewing a television station after the auto/manual search for channels.
1. Press the FUNCTION button to TV mode.
2. Press the CH+ or CH- button to select a channel, or press the number button on the remote to
select the channel you want to watch.
• For channels 1 to 9, enter one-digit channel number.
• For channels 10 to 99, enter two-digit channel number.
• For channels 100 or over, enter three-digit channel number.
NOTE
• When a channel is selected, the channel number is displayed on the top right corner of the screen.
This number will disappear after a few seconds.
Manual searching for TV channels
1. Connect the TV antenna.
2. Connect the AC adapter and AC cord.
3. Press the
/ ON button to turn on the unit.
4. Press the ENTER button.
5. Press the
or button to select “Air” or “CATV”, then press the
ENTER button to start auto scan.
6. The unit will immediately search all channels for those with adequate
signal strength and store those channels with signals in memory. The
unit will take a short minutes to finish auto scan and aftter this is
completed, the unit will switch to the first channel found.
ATSC TV mode:
Press the DISPLAY button, the upper
window will pop up, then press the
DISPLAY button again, the lower window
will pop up. Press the DISPLAY button
once to exit.
NTSC TV mode:
Press the DISPLAY button, the upper
window will pop up, then press the
DISPLAY button once to exit.
RFCH 13
Press“MENU” ToExit AutoScan
Found 0
:SELECT
“ENTER”: CONFIRM
PROCEEDWITH AUTOSCAN?
NO
YES
:SELECT
“ENTER”: CONFIRM
PLEASESELECT ANTENNATYPE.
AIR
CATV
1. Press the TV MENU button, then press the button to TV
CHANNEL SETTING.
2. Press the button to select ANTENNA. Use the or button to
select AIR or CATV.
3. Use the
button to select Auto Scan.
4. Press the ENTER button to enter sub menu of Auto Scan.
5. Use the button to select “Start to Scan” in the sub menu.
6. Press the ENTER button to start the search for TV channels.
7. The screen will show the first received channel when auto search is completed.
2.3 Xxxxxxx Xxxx
AUDIO 1/1(L+R) FTA
2007/01/31 07:38 07:00-08:00 TV LEVEL: Good
Xxxx xx xxxxxx xx xxxx xx xxxxxxxx x xxxx xxxxx xxx xx xxx
xxxxxxxxxxx xx xxxx xxxxx xx x xxxxx xxx xxxxxx x xxxxxx xxx
xxxxxx xx xxxx xx xxxxxxxx x xxxx xxxxx xxx xx xxx
xxxxxxxxxxx xx xxxx xxxxx xx x xxxxx xxx xxxxxx x xxxxxx xxx
Position no.
Time information
Audio
information
ATSC data information
(only ATSC)
Signal
strength
(only ATSC)
Rating
information
ATSC data
information
(only ATSC)