Filter
Top Products
REMOTE CONTROL OPERATION
BATTERY INSTALLATION
Before attempting to operate your Remote Control,
install the batteries as described below.
1) Turn the Remote Control face down. Press
down on the ridged area of the battery cover
and slide it off.
2) Install two “AAA” batteries as shown. Make sure
that proper polarity (+ or -) is observed.
3) Slide the cover back until it clicks.
The remote control will operate the VOH560PKG,
It is not a universal remote control and will not control
equipment from other manufacturers.
Remote Controlled Monitor Functions
1. POWER ON/OFF
Press this button to turn the VOH560 On. The channel number or current video source will be
displayed on screen, and the picture will appear in a few seconds. Press the button again to turn
the VOH560 Off.
2. VOLUME UP/DOWN BUTTONS
Use these buttons to raise or lower the volume level of the headphone jacks or external speaker if
installed. They are also used to make picture adjustments in picture select mode.
Note: These buttons will not affect the volume of wireless headphones or a wired RF modulator.
When using these devices the volume must be adjusted with the headphone volume control or
with your radio’s volume control (see page 13, Headphones, or page 14, Wired FM Modulator).
3. PICTURE SELECT BUTTON
Each time this button is pressed, the on screen picture adjustment display cycles through
“adjustment bars” for CONTRAST, BRIGHTNESS, COLOR and TINT. Once the desired adjustment
bar is displayed, use the VOLUME UP/DOWN buttons to adjust the setting. The display will
automatically turn off if no adjustments are made within 6 seconds, or if any other button is
depressed.
4. SOURCE SELECT BUTTON
Any video equipment connected to the AUDIO / VIDEO inputs can be used with the monitor by
pressing this button. Each time the button is pressed, the Audio / Video source will change in the
following sequence VIDEO 1 and VIDEO 2.
1
2
3
4
7
9
8
6
5
-11-
PICTURE
SELECT
+
WIRED HEADPHONE
VOLUME CONTROL
POWER
PLAY
REW FWD
STOP
VIDEO
or GAME
REPLAY