Autostart AS-3472TW-FM Universal Remote User Manual


 
User Guide P. 7
Button LCD Beep(s)
L --01 Trunk button
Temperature
L --01 Start button
(pressed more than 3s)
CWM or MTF text for 1s 1 beep
L --02 Lock button
(2
nd
car unlock)
LOCK and Lock icon 1 beep
L --02 Unlock button (2
nd
car unlock)
ULOCK and Unlock icon 2 beeps
L --02 Trunk button(2
nd
car
trunk)
TRUNK text for 1s 1 beep
L --02 Start button(2
nd
car
start)
START text for 1s 1 beep
L --03 Lock button
(Channel 1)
1 beep
L --03 Unlock button
(Channel 2)
1 beep
L --03 Trunk button
(Channel 3)
1 beep
L --03 Start button
(Channel 4)
1 beep
Vehicle Presets
Heater & Heated Seat
When leaving the vehicle it is recommended to preset the accessory controls in preparation for the
next remote start. Settings for the blower motor (fan), front and rear, as well as heated seats (if
equipped) should not be left on
HIGH. It is recommended to leave the settings on LOW or MEDIUM
instead.
Windshield Wipers, Radio & Headlights
Certain vehicles require the radio and / or windshield wipers and / or headlights circuits to become
energized while running under remote start. When leaving the vehicle you must ensure that the
windshield wipers and headlights switches are
OFF. Leaving the headlights switch ON on certain
types of vehicles could cause them to remain
ON even after remote starter shutdown, resulting in a
dead battery.
Arming the Starter Kill
The Starter Kill (if installed) can be configured by the installer either to Passive Mode (so as to arm
automatically) or Active Mode (so as to require the user’s intervention for arming). By default, your
Remote Car Starter is configured to Passive Mode.
¾ Passive mode:
To arm the Starter Kill, press the LOCK button on the transmitter, OR
In Passive Mode, the Starter Kill will also automatically arm 1 minute (by default) or 3 minutes
(if configured this way) after the ignition is turned
OFF or once the last door is closed (if the
doors are monitored).
- The LED on the antenna will flash quickly during the countdown preceding the
activation of the Starter Kill.
- Once the activation countdown expires, the LED will send a series of quick double
flashes to indicate that the Starter Kill is now armed.
To disarm the Starter Kill, press the UNLOCK button on the transmitter.