Filter
Top Products
ISDF
5. Audio Setup Page
SPEAKER SETUP
1. Press the SETUP button on the remote control during STOP or PLAY mode to enter the on-screen Audio Setup
page.
the remote control during STOP or PLAY mode to enter the on-screen Audio Setup
page.
2. Use the cursor to select SPEAKER SETUP. Press ENTER to display the SPEAKER SETUP page. 2. Use the cursor to select SPEAKER SETUP. Press ENTER to display the SPEAKER SETUP page.
DOWNMIX
The DOWNMIX feature allows you to combine (mix) several discrete digital channels of audio into two channels. You
would enable DOWNMIX if you did not have a 5.1 Channel audio system.
LT/RT: Left and Right output mode ( Either Left or Right channel Audio output while playing )
V SURR: Virtual Surround: Stereo output mode
OFF: Turn off the DOWNMIX mode. 5.1 Channel audio can be enabled only if DOWNMIX is set off and the rest
of speaker setup is activated.
NOTE: The selections below allow for 5.1ch audio. These settings are only available if
DOWNMIX is OFF and CENTER, REAR, and SUBWOOFER are ON. For 5.1ch audio, all
connections including CEN, SW, SL, SR, FL, and FR have to connect between the DXP-1000 G2
Player and your amplifier by either optical or coaxial cable and SPDIF OUTPUT on the Audio
Setup Page must be set to SPDIF/RAW.
CENTER
Set CENTER, REAR, and SUBWOOFER to ON only if you
have your player connected to a 5.1ch surround sound
system.
These speaker settings are used in conjunction with the
DELAY settings on the next page to enhance the surround
sound audio experience.
DTS 6.1ch output is supported using the six audio outputs, the
optical connection, or the coaxial connection. Use the coaxial
for best results. You must select SPDIF/RAW on the Audio
Setup Page.
20