Filter
Top Products
10
PGXG-61B/PGWX-61B/PGWU-61B - - 2015/04/01
1. Safety
To ensure the highest optical performance and resolution, the projection lenses are specially treated with an y
anti-reective coating, therefore, avoid touching the lens. To remove dust on the lens, use a soft dry cloth. Do
not use a damp cloth, detergent solution, or thinner.
Rated maximum ambient temperature, ta= 40 °C (104 °F). y
The lamp house shall be replaced if it has become damaged or thermally deformed. y
Horizontal and vertical projector tilt ranges: The projector is designed to work in a table or ceiling mounted posi- y
tion, but tilting is allowed. Side to side tilt, however, must not exceed +/- 20°. This limit ensures that the lamp in
the projector operates properly and safely.
A: Tilting allowed without problems -
B: No tilting allowed in this area -
B
B
AA
20°
20°
20°
20°
B
B
AA
20°
20°
20°
20°
Front View Side View
On servicing
Do not attempt to service this product yourself, as opening or removing covers may expose you to dangerous y
voltage potentials and risk of electric shock.
Refer all servicing to qualied service personnel. y
Attempts to alter the factory-set internal controls or to change other control settings not specially discussed in y
this manual can lead to permanent damage to the projector and cancellation of the warranty.
Unplug this product from the wall outlet and refer servicing to qualied service technicians under the following y
conditions:
When the power cord or plug is damaged or frayed. -
If liquid has been spilled into the equipment. -
If the product has been exposed to rain or water. -
If the product does not operate normally when the operating instructions are followed. Adjust only those -
controls that are covered by the operating instructions since improper adjustment of the other controls may
result in damage and will often require extensive work by a qualied technician to restore the product to
normal operation.
If the product has been dropped or the cabinet has been damaged. -
If the product exhibits a distinct change in performance, indicating a need for service. -
Replacement parts: When replacement parts are required, be sure the service technician has used original y
Barco replacement parts or authorized replacement parts which have the same characteristics as the Barco
original part. Unauthorized substitutions may result in degraded performance and reliability, re, electric shock
or other hazards. Unauthorized substitutions may void warranty.
Safety check: Upon completion of any service or repairs to this projector, ask the service technician to perform y
safety checks to determine that the product is in proper operating condition.
Possible explosion hazard: Always keep in mind the caution below: y
Caution: Do not touch a lamp during operation and right after is turned off as it is extremely hot. Lamp contains
mercury. it’s brokeage might cause mercury or broken glass to follow out of lamp housing. To avoid exposure
the risk of mercury poisoning. Don’t drop, hit, force or scratch while handing a lamp.