Filter
Top Products
ENGLISH
U-PHONO UFO202 User Manual
4
Note: The PHONO inputs only support moving magnet
cartridges. These are the most common type, so unless
you know your player uses a moving coil cartridge,
assume that your system will work.
Headphones output
[5]
– Plug your headphones into the
PHONES output using a ⅛" mini plug.
Headphones volume
[6]
– Adjust the headphones volume
with the adjacent control.
USB cable
[7]
– Plug the USB cable into a free USB port on
your computer.
Power indicator
[8]
– Upon connection, the UFO’s power
indicator will light up and the computer should automati-
cally recognize the connection.
Software Installation
This device requires no special setup or drivers, just plug it •
into a free USB port on a PC or Mac computer.
The UFO202 comes with a free version of Audacity editing •
software. This will help make the transfer process quick and
simple. Simply insert the install CD into your CD-ROM drive
and follow the instructions. The CD also contains VST plug-
ins, ASIO drivers and various freeware.
For other audio needs, such as advanced editing, instru-•
ment recording, sequencing, etc., a free version of energyXT2
Compact BEHRINGER edition is also included.
Hookup Diagram
Hooking up a record player
1. To transfer music from a record player, a special preampli-
cation process must take place in order to boost the low signal
level coming from the player. To do this, simply move the LINE/
PHONO switch on the UFO202 to the right (PHONO selected).
2. Connect a stereo RCA cable from the record player outputs to
the RCA inputs on the UFO202. The player will also likely have
a ground cable that needs to be attached to the ground terminal
on the UFO202.
3. Connect a monitoring device. You may plug speakers into the
RCA outputs or connect a pair of headphones to the PHONES
output.
4. Connect the attached USB cable to a free USB port on your
computer.
Hooking up a tape player
1. Move the LINE/PHONO switch on the UFO202 to the left
(LINE selected).
2. Connect a stereo RCA cable from the tape player outputs to
the RCA inputs on the UFO202.
3. Connect a monitoring device. You may plug speakers into the
RCA outputs or connect a pair of headphones to the PHONES
output.
4. Connect the attached USB cable to a free USB port on your
computer.
Recording Process
After hookups have been made and software installed, you •
are ready to record the audio. Make sure your audio recording
program is set to record input from the USB port. For simple
record, cut, and export of stereo audio, you may prefer to use
Audacity. For more extensive editing, energyXT2 Compact
may be the best choice
If recording from a tape player, make sure the player's volume •
is turned up all the way.
Adjust the input sensitivity of the recording program to •
achieve optimal sound quality. Too much signal will cause the
recording to distort; too little signal will sound faint and thin,
so record a test clip to ensure quality sound. The recording
program should have meters that display the levels as the
audio streams.
Headphone Out
RCA Outputs
RCA Ins
Ground
Line/Phono
Computer USB
Headphone Out
RCA Outputs
RCA Ins
Line/Phono
Computer USB