Belkin AV62300-16 TV Cables User Manual


 
RazorVision
Video Enhancement Cable
Troubleshooting Guide (continued)
If you wish to mount the RazorVision to the inside of
your cabinet or to your wall, please follow these steps:
1.
Cut out the template on the following page along the
perforated lines.
2.
Place the page where you want to install the
RazorVision.
3.
Use a hammer and a small nail to make a starter hole
for the screws.
4.
Remove the template page from your cabinet or wall.
5.
Tighten the supplied screws into your cabinet or
wall, stopping approximately
1
/
8
inch (3mm) short
of fully tightened.
6.
Place the RazorVision mounting holes over these screws
and then slide the unit down approximately
1
/
4
inch
(6mm) until it locks in place.
Replacement screws to mount the RazorVision are
available at any hardware store; ask for #6 round head
slotted wood screws.
Instructions for Mounting
RazorVision Unit
12