Filter
Top Products
Maintenance50
Timing of replacing the light source
When the Light indicator lights up red or a message appears suggesting it is time to
replace the light source, please consult your dealer.
The following light source warning displays will remind you to change the light source.
"XXXX" shown in the above messages are numbers that vary depending on different models.
Replacing the light source
Do not replace the light source by yourself. Please contact your dealer.
Status Message
Install a new light source for optimal
performance. If the projector is normally run with
Economic selected (See "Getting to know the
light source hour" on page 49), you may continue
to operate the projector until the next hour light
source warning appears.
Press ENTER to dismiss the message.
It is strongly recommended that you replace the
light source at this age. The light source is a
consumable item. The light source brightness
diminishes with use. This is normal light source
behavior. You can replace the light source
whenever you notice that the brightness level has
significantly diminished.
Press ENTER to dismiss the message.
The light source MUST be replaced before the
projector will operate normally.
Press ENTER to dismiss the message.
OK
Order Replacement Light Source
Light source>XXXX Hours
Please contact your dealer for replacing new light
source
Notice
OK
Notice
Replace Light Source Soon
Light source>XXXX Hours
Please contact your dealer for replacing new light
source
OK
Notice
Replace Light Source Now
Light source>XXXX Hours
Light source usage time exceeded
Please contact your dealer for replacing new light
source
OK
Out of Light Source Usage Time
Please contact your dealer for replacing new light
source
WARNING