Filter
Top Products
24
Connecting with video equipment
Entering the password recall procedure
1. Make sure the Input Password page displays on screen. Press and
hold EXIT on the projector or remote control for 3 seconds. The
projector will display a coded number on the screen.
2. Write down the number and turn off your projector.
3. Seek help from the local BenQ service center to decode the number.
You may be required to provide proof of purchase documentation to
verify that you are an authorized user of the projector.
Changing the password
1. Press MENU on the projector or remote control and then press / until the Advanced Setup
menu is highlighted.
2. Press / to highlight Password and press ENTER. The Password page displays.
3. Highlight Change Password and press ENTER. The Input Current Password page displays.
4. Enter the old password.
• If the password is correct, the message "Input New Password" displays.
• If the password is incorrect, the password error message displays lasting for three seconds, and
the message "Input Current Password" displays for your retry. You can either press MENU
to cancel the change or try another password.
5. Enter a new password.
IMPORTANT: The digits being input will display as asterisks on-screen. Write your selected password
down here in this manual in advance or right after the password is entered so that it is available to you
should you ever forget it.
Password: __ __ __ __ __ __
Keep this manual in a safe place.
6. Confirm the new password by re-entering the new password.
7. You have successfully assigned a new password to the projector. Remember to enter the new
password next time the projector is started.
8. To leave the OSD menu, press MENU.
Disabling the password function
To disable password protection, go back to the Advanced Setup >
Password > Password menu. Highlight Power On Lock and then
press / to select Off. The message "Input Current Password"
displays. Enter the current password.
• If the password is correct, the OSD menu returns to the
Password page with "Off" shown in the row of Power On
Lock. You will not have to enter the password next time when
turning on the projector.
• If the password is incorrect, the password error message
displays lasting for three seconds, and the message "Input
Current Password" displays for your retry. You can either
press MENU to cancel the change or try another password.
Note that though the password function is disabled, you need to keep the old password in hand should
you ever need to re-activate the password function by entering the old password.
Please write down the recall code,
and contact BenQ
Customer Center.
Recall code:
XXX XXX XXX XXX
RECALL PASSWORD
Back
Password
Change Password
Power On Lock
Off
Back
ENTER