Filter
Top Products
Page 15
724-746-5500 | blackbox.com
Chapter 3: Installation and Configuration
Table 3-1. Pull-up and pull-down
resistor settings.
Mode PU Setting PD Setting
RS-232 Always off Always off
RS-422 Always off Always off
RS-485 Always on Always on
3.4.3 Line Termination
A 120-ohm resistor is across each RS-422/485 input. If multiple devices are
configured in an RS-485 network, only the devices on each end should have the
termination in place.
Termination configuration is software selectable for both full- and half-duplex
RS-485. By default, line termination is disabled, and this configuration can be set
by placing a check next to “Enable Termination” in the “RS-485 Advanced
Configuration” field, as shown in Figure 3-3.
Figure 3-3. Enable Termination.