Filter
Top Products
Compact CAT5 Audio/Video Splitter
8
4. Using Category-5 cable connect one or more AC155A receivers to
the unit's RJ45 outputs. The outputs are labeled PORT A and
PORT B on the AC154A-2 or OUT 1 through OUT 8 on
AC0154A-8.
5. Connect the remote monitor and speakers to the receiver unit and
attach the power adapter to the receiver. Please refer to AC155A
User’s Manual for further details.
CAUTION
Before plugging in your remote monitor, verify that the AC line is
properly wired and that a protective ground (green) wire is
established with NO potential difference between both the sender
and receiver locations (The UTP splitter can tolerate up to 5 v peak-
to-peak ground noise between the two locations) . Failure to ensure
good grounding can result in erratic operation and possible shock
hazards with severe damage to your equipment. If an LCD is being
used at the remote location, verify that the LCD ground is tied to
power-line ground. If not, then ground the receiver unit by adding a
ground strap (see troubleshooting section for more information).
NOTICE
Do not connect this unit to any LAN device such as network cards
or hubs as this may damage the AC155A and/or the LAN device. Use
EIA/TIA 568B standard straight-through patch wiring as shown
below. Do not use crossover cables.
EIA/TIA 568B WIRING STANDARD
PIN Wire Color
1 White w/ Orange Stripe
2 Orange
3 White w/Green Stripe
4 Blue
5 White w/Blue Stripe
6 Green
7 White w/Brown Stripe
8 Brown