Filter
Top Products
EN
|
8
MON150CL | Instruction Manual | Installation
Bosch Security Systems | May 20, 2005
5.2 Desktop Installation
The MON150CL monitor is delivered with a 3-pole
US-style power cord and a 3-pole Euro-style power
cord. Use the US-style power cord where 120 VAC,
60 Hz power is available; and use the Euro-style
power cord where 230 VAC, 50 Hz power is available.
Connect the bayonet connector from the power supply
to the power input connector on the rear side of the
LCD panel, as shown in Photo A. The monitor
automatically adjusts to either power input voltage.
Photo A
5.3 Connecting the Composite Video
Signal to the Monitor
There is one (1) RCA connector located on the rear of
the monitor for composite video input (please see
Figure 2 on Page 6). Also included is one (1) RCA to
BNC adapter used to connect a BNC cable line as
shown in Photo B and Photo C.
Photo B
Photo C
5.4 Connecting the Y/C (S-video) Signal
to the Monitor
There is one (1) mini-DIN type connector for the
S-video (Y/C) input (please see Figure 2 on Page 6 and
Figure 3 below).
NOTE: Both Y and C inputs are terminated with 75Ω.
Figure 3: Y/C Connection Pinout
5.5 Connecting Audio to the Monitor
There is one (1) set of mini phone jacks for the audio
connector (please see Figure 2 on Page 6 and Photo D
below).
Photo D
1
3
4
2
1. GND
2. GND
3. Y-signal IN
4. C-signal IN