Bosch Appliances MON150CL Flat Panel Television User Manual


 
EN
|
9
5.6 Connecting the Analog VGA Signal
to the Monitor
There is one (1) 15-pin D-sub connector (Figure 4) for one
analog VGA input. Refer to Figure 2, item B.
Figure 4: Analog VGA Connector
5.7 Ventilation
To prevent overheating, ensure that the ventilation
openings on the rear of the monitor are not covered.
6.0 OPERATION
6.1 Front Panel Controls (Figure 1)
AUTO (Input) Press this button to display the input
signal which is selected on the screen
+/- Press the ‘+’ or ‘-’ button to move the
cursor to the targeted parameter in the
OSD main menu. Press the ‘+’ or ‘-
button to adjust the value of the selected
parameter in the OSD sub-menu.
MENU Press this button to open the main OSD
menu. Use this button to confirm a value
for a parameter in the OSD Menu.
Power LED Power on (Green)
Identification Stand by (Amber)
POWER Press this button to turn on or turn off
the monitor
6.2 On-screen Display (OSD) Menu
6.2.1 Video Setting (CVBS/S-VIDEO)
Saturation
1. Press Menu to open the OSD Main menu
2. Press the ‘+’ or ‘-’ button to highlight an option,
then press Menu to modify the value of the option
Contrast Adjusts the contrast value
(0-100)
Brightness Adjusts the brightness value
(0-100)
Tint Adjusts the tint value (NTSC only)
(0-100)
Saturation Adjusts the color value
(0-100)
Volume Adjusts the volume
(0-31)
Exit Exits the OSD menu
6.2.2 Colour Setting (RGB / VGA)
Colour Setting
1. Press Menu to open the OSD Main menu
2. Press the ‘+’ or ‘-’ button to highlight an option,
then press Menu to modify the value of the option
Contrast Adjusts the contrast value
(0-100)
Brightness Adjusts the brightness value
(0-100)
Gamma Correct
Opens an optimum Gamma curve
(0/1/2/3)
Colour Adjust
Opens the color menu. Select a color
then press Menu to adjust the value of
the selected color.
Exit Exits the Colour OSD menu setting
MON150CL | Instruction Manual | Operation
Bosch Security Systems | May 20, 2005