Filter
Top Products
30 en | Installing the Monitor Full HD LCD Monitors
F.01U.172.600 | 1.0 | 2010.10 User’s Manual Bosch Security Systems, Inc.
Figure 5.4 UML-422-90 Mounting Hole Dimensions
5.3 Connecting the Composite Video Signal to
the Monitor
There are two (2) BNC connectors located on the rear side
panel of the monitor for composite video inputs and two (2)
BNC connectors for composite video outputs (see Figure 3.2
and Figure 3.5).
Note: All video inputs are passive loop-through. The impedance
is automatically set to 75 Ohm by the input of the signal on the
input connector, while operating in a single connection mode
(see Figure 5.10). If a cable is also connected to the output
connector, the video signal can be passed on to another
monitor connected to it via the passive loop-through function.
Up to three (3) monitors may be connected in this manner (see
Figure 5.11).
Note: To select between AV1 and AV2, press the Enter or Input
button; then press the Up or Down arrow key on the front of the
monitor.
400 mm
200 mm