Filter
Top Products
19
System Installation Instructions
Making the temporary headset connection before connecting to power
Plug the special headset connector into the AUX jacks on the rear of the media center (Figure
17). This is for temporary use during steps for “Finishing the installation” on page 21.
Figure 17
Headset connection for use
in the final setup steps
Connecting the system to power
Connect the two AC power (mains) cords in the following order:
1. Plug the small end of the Acoustimass
®
module power cord into the AC power jack on the
connector panel of the Acoustimass module (Figure 18). Plug the other end of the power
cord into an AC (mains) outlet.
2. Turn the Acoustimass module POWER switch to on ( l ).
Figure 18
Power connection of the
Acoustimass module
5
5
TV
SENSOR
IR
EMITTER
SERIAL
DATA
SPEAKER
ZONES
1
2
1.1A
33V DC POWER
AM
FM 75
ANTENNA
OPTICAL OPTICAL
INPUT
OUTPUT
AUDIO OUTPUTS
DIGITAL DIGITAL
R
L
RECORD
DIGITAL
R
L
DIGITAL
R
L
DIGITAL
R
L
DIGITAL
R
L
TAPE
AUDIO INPUTS
AUX VCR TV
VIDEO INPUTS
COMPOSITE S-VIDEO
COMPOSITE S-VIDEO
VIDEO OUTPUTS
R
Temporarily remove the
cable/satellite box cable
if it is connected
AUX
OUTPUTS TO
CUBE SPEAKERS
AUDIO
INPUT
POWER
FRONT SURROUND
100-120/200-240V AC
50/60 Hz
350W MAX.
L
C
R
L
R
Connector panel
Power switch
AM259777_02_V.pdf • April 23, 2002