BOXLIGHT DLP Projection Television User Manual


 
Lamp Safety
WARNING:
To replace the lamp, turn off the power and unplug the power cord. To avoid burns,
wait 45 minutes before opening the lamp door. Follow all instructions provided in
this
User’s Guide
. See “Changing the Lamp Module” on page 34.
When you open the lamp module door, be careful not to touch the hot surfaces
inside.
In the unlikely event of the bulb rupturing, thoroughly clean the area behind the
projector and discard any items that might have been contaminated with broken
glass.
CAUTION:
Never operate your projector without the lamp module or lamp module door.
Doing so may damage the projector.
Do not touch the glass portion of the new lamp module with your hands or allow it
to touch other objects as this may damage it and shorten its operational life.
Do not drop the lamp module as the glass may shatter.
Battery Safety
Read and follow all warnings and instructions supplied by the battery manufacturer.
WARNING: Keep batteries away from children.
CAUTION:
Store batteries in their original packaging.
When inserting batteries, verify that the (+) and (-) terminals are aligned correctly.
Replace all batteries of a set at the same time.
Do not mix new batteries with used ones.
Do not use batteries of different chemistries, capacities, brands or sizes together.
Leakage could result.
Do not disassemble, recharge, or short-circuit batteries.
Do not subject batteries to high temperature or fire.
Discard used batteries according to all applicable local and national regulations.
Laser Safety
WARNING:
To reduce the risk of injury to the eyes, do not look directly into the laser light emitted from
the aperture on the Remote Control and do not point the laser light into anyone’s eyes. This
remote control is equipped with a Class IIIA laser that emits radiation.
NOTE:
Do not leave the remote control close to the cooling fan outlet of the projector.