Bryston BR2 Manual

Open as PDF

next previous

BR2 HANDHELD INFRA-RED REMOTE CONTROL

for use with the following Bryston models:

• BCD-1 CD player

• BDA-1 Digital-to-Analog Converter

• B60R Integrated Amplifier / BP6 Preamp

• B100 Integrated Amplifier / BP16 Preamp

• BP26 Preamp

FEATURES:

●

Replace battery by removing bottom cover plate by removing the four Philips screws on the rear of the remote unit.

●

Automatic motion-sensing backlight.

Can be disabled by entering the 3 digit code “792”

●

Power saving ambient light level sensor inhibits backlight when not needed.

●

Solid machined aluminum enclosure and push buttons.

●

Can be used with over 7 different Bryston amps & preamps

●

Special function codes customize preformance

PROGRAMMING the BR2 REMOTE CONTROL:

 1st) PressandholdtheCODEbuttonontheBR2remoteuntiltheredLEDbeginstoash(usuallytakesabout5

seconds).

2nd) Enter a three digit code as follows:

7xx: SP2 PreAmp/Processor

712: B100 integrated amplifier

715: BCD-1 *

721: BP26 preamp *

722:B60Rintegratedamplier&BP6preamp

Other codes:

792:Disablemotionsensorbacklightcontrol

797:Enablemotionsensorbacklightcontrol

The red LED will ash twice after a code has been entered successfully.

* See also Model Select Buttons below.

MODEL SELECT BUTTONS:

The D/A, CD and PREAMPbuttonsallowswitchingBR2operationdirectlyamongstBryston’sBDA-1, BCD-1 and various

BrystonPreamps(dependsonwhichonehasbeenpreviouslyselectedusingthecodesabove).

PROGRAMMING/CONTROLLING the B100/BP16 via the BR2 REMOTE CONTROL:

Press the CODE button on the remote control until the red LED lights and then enter the 3 digt code as listed below. The LED

will flash to confirm transmission and then extinguish.

001:selectanalogsource1(A/D) 019: balance left 082:selectdigitalsource2(D2)

002:selectanalogsource2(AUX/PH) 020: balance right 083:selectdigitalsource3(D3)

003:selectanalogsource3(CD) 029: power on 084:selectdigitalsource4(D4)

004:selectanalogsource4(TUNER) 058: mute on 245: set/reset Pass Through mode

005:selectanalogsource5(TV) 059: mute off 247: Set Trigger 2 for current source

006:selectanalogsource6(VIDEO) 061: record monitor toggle 248: Clear Trigger 2 for current source

007: volume up 062: record monitor on 255:Systemreset;restoredefaults

008: volume down 063: record monitor off

WhilemostofthesecodesareprimarilyintendedforcontrollingtheB100/BP16viait’sRS232port(withsystemcontrol-

lerssuchasthoseprovidedbyCrestronorAVX,etc)theycanalsobesentviatheBR2infra-redremote.

For more information see the B100 Owners Manual or the BP16 Owner’s Manual.