Filter
Top Products
23
TROUBLE SHOOTING
Check the following guide for the possible cause of a problem before contacting service.
Symptom
No Power
The power is on, but DVD
player does not work
No Picture
The playback picture is poor
The DVD player does not
start playback
No Sound
The Remote Control does
not work properly
Cause
• The power cord is disconnected.
• No disc is inserted.
• The TV is not set to receive DVD signal
output.
• The video cable is not connected
securely.
• The connected TV power is turned off
• The equipment connected with the au-
dio cable is not set to receive DVD sig-
nal output.
• The audio cables are not connected
securely.
• The power of the equipment connected
with the audio cable is turned off.
• The Digital Audio Output is set to the
wrong position.
• The disc is dirty.
• No disc is inserted.
• An unplayable disc is inserted.
• The disc is placed upside down.
• The disc is not placed with the guide.
• The disc is dirty.
•A menu is on the TV screen.
• The Rating level is set.
• The remote control is not pointed at the
remote sensor of the DVD player.
• The remote control is too far from the
DVD player.
• There is an obstacle in the path of the
remote control and the DVD player.
• The batteries in the remote control are
exhausted.
Correction
• Plug the power cord into the wall outlet and unit
securely.
• Insert a disc. (Check that the DVD or audio CD
indicator in the DVD display is lit.)
• Select the appropriate video input mode on the
TV so the picture from the DVD player appears
on the TV screen.
• Connect the video cable into the jacks
securely.
•Turn on the TV.
• Select the correct input mode of the audio re-
ceiver so you can listen to the sound from the
DVD player.
• Connect the audio cable into the jacks
securely.
•Turn on the equipment connected with the au-
dio cable.
• Set the Digital audio Output to the correct
position, then turn on the DVD player again by
pressing the POWER button.
• Clean the disc.
• Insert a disc
• Insert a playable disc. (Check the disc type,
color system and Regional code.)
• Place the disc with the playback side down.
• Place the disc on the disc tray correctly inside
the guide.
• Clean the disc.
• Press the SET UP button to turn off the menu
screen.
• Cancel the Rating function or change the rating
level.
• Point the remote control at the remote sensor
of the DVD player.
• Operate the remote control within about 23ft
(7m).
• Remove the obstacle.
• Replace the batteries with new ones.