6
Getting Started
Accessories
AC Line Cord DC Car Adaptor (Cigarette Adaptor)
Remote Control
AV Cable
DC CAR ADAPTOR (Cigarette Adaptor) / CORD
The supplied DC car adaptor/cord is designed for use with vehicles
equipped with a 12 volt negative ground electrical system only.
The equipment is compatible if the negative (-) terminal of the
battery is connected to the vehicle’s metal body/chassis. If unsure,
contact the vehicles’s dealer.
Plug the small end of the car adaptor into the DC 12V jack and
then plug the other end into the cigarette lighter socket. This
indicator lights when the power is on.
PRECAUTIONS
• USE ONLY THE SUPPLIED DC CAR ADAPTOR/CORD PROVIDED. OTHER ADAPTORS COULD DAMAGE THE PLAYER.
• IF THE INSIDE OF THE VEHICLE’S CIGARETTE LIGHTER SOCKET IS DIRTY WITH ASHES OR DUST, THE PLUG SELECTION
MAY BECOME HOT AS A RESULT OF POOR ELECTRICAL CONTACT. BE SURE IT IS CLEAN BEFORE USE.
• AFTER USE, DISCONNECT THE CORD’S PLUGS FROM BOTH THE PLAYER AND THE CIGARETTE LIGHTER.
• SHOULD THIS PLAYER CAUSE RECEPTION INTERFERENCE TO NEARBY RADIO. INCREASE THE DISTANCE BETWEEN PLAYER
AND RECEVIER.
FUSE REPLACEMENT
Should the player fail to operate with the DC car adaptor/cord, check the fuse
(2.5A). If blown, check all connections and inspect the cord for any damage.
Always replace the fuse with same type and rating.
If the fuse blows again after replacement, this indicates a potential problem. DO
NOT replace fuse with a higher rating. Doing so, may cause damge to the player.
Battery installation (remote control unit)
1. Remove the battery cover.
2. Insert two batteries (AA, R6, UM-3 types) making sure the polarity (+/-) matches the marks inside the unit.
3. Replace the cover.
– Do not attempt to recharge, short-circuit, disabssemble, heat or throw
the batteries into the fire.
– Do not mix old and new batteries
Note : Weak batteries can leak and serveraly damage the remote con-
trol unit.
Indicator
Fuse
+
—
+
—
TO DC 12V JACK