Filter
Top Products
8
Unbalanced Audio Outputs
Single-ended conventional stereo outputs for connection to the line-level phono/RCA inputs of an
amplifier.
Balanced Audio Outputs
The DacMagic also features true balanced (XLR) outputs. This is a higher quality output that can
reject noise and interference with equipment with balanced inputs. These balanced outputs are
ideally suited for connection to the Cambridge Audio 840A or 840E amplifiers. XLR connectors should
be wired as follows:
Pin 1 – Ground; Pin 2 – Hot (in-phase); Pin 3 – Cold (phase-inverted).
Digital Outputs
The digital outputs allow a digital recording device to be connected. These outputs loop or pass-
through unprocessed digital audio from the selected digital input. Two types are available (both the
co-axial and the optical are active concurrently and can be used to connect and run equipment at the
same time):
S/P DIF co-axial – to obtain best results, use a high quality 75 ohm digital RCA interconnect cable (not
one designed for normal audio use).
12V 1500mA
Use supplied
PSU only!
Designed in the UK, Made in China
www.cambridge-audio.com
DacMagic Upsampling DAC
Manufactured in an ISO9001 approved facility
Caution
Serial Number Label Removed
Digital Outputs
S/P DIF
Co-axial
Toslink
Optical
S/P DIF
Co-axial
Toslink
Optical
S/P DIF
Co-axial
Toslink
Optical
USB In
Right — Balanced Output — Left
Unbalanced
Output
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1) This device may not cause harmful interference;
2) This device must accept any interference, including interference that may cause undesired operation.
Left
Right
Digital Input 2Digital Input 1
LR
Incorporating Q5
™
from:
ANAGRAM
TECHNOLOGIES
1
1
2
2
3
3 4 5
6
7
Rear panel connections